Zhermack Zetaplus Soft Putty + Light + Activator II C100740

TECHNICAL SPECIFICATIONS

• Type of setting -:  Normal Set
• Working time -: 1:15 (min:s)
• Time in mouth -: 3:15 (min:s)
• Setting time -: 4:30 (min:s)
• ISO 4823 -: Type 0 Putty Consistency
• Strain in compression -: 2 - 5 %
• Elastic recovery -: > 98 %
• Linear dimensional change (after 24 h) -: < 0.2 %

Dosage:

• Use the measuring spoon to dose the required quantity of Zetaplus and spread it out over your hand (note: for the correct dosage the putty should be level with the top of the measuring scoop). Press the rim of the measuring scoop onto the putty once for each measure dosed. For each measure of material, apply two strips of Zhermack Indurent Gel as long the measuring scoop (4 cm.)
• When using Zhermack Indurent Liquid, dose 5 – 6 drops of hardening liquid for each scoop of putty used.

Mixing:

• Fold and knead the putty energetically with your fingertips for about 30 sec., until the colour is even, without any stripes
• Spread out the putty over the impression tray. The working time including mixing time is about 1 min. 15 sec.
• Put into the mouth and wait until it is set, which will take about 3 min. 15 sec.

• High initial flowability and excellent rigidity after hardening
• Thixotropy for the washes
• High tear resistance
• Oranwash VL: Low viscosity, extremely fluid, hydrocompatible, polysiloxane.
• High initial flowability and excellent rigidity after hardening
• Thixotropy for the washes
• High tear resistance
• Oranwash VL: Low viscosity, extremely fluid, hydrocompatible, polysiloxane.