Waldent FlexiGum VPS A-Silicone Putty + Light Body Combo Kit

FlexiGum VPS – Light Body

• Working Time : 2 min
• Intraoral Setting Time : 3 min 30 sec

FlexiGum VPS– Putty

• Working Time : 1 min 30 sec
• Intraoral Setting Time : 3 min

Mixing FlexiGum Putty:

• Dispense equal lengths of Putty Base and Catalyst onto a mixing pad.
• Thoroughly knead the two components together until a uniform color is achieved.
• Once mixed, quickly place the putty into the impression tray and seat it firmly over the dental arch.
• Hold in place until set.

Mixing FlexiGum Light Body:

• Attach a mixing tip to the Silicone Base and Catalyst cartridges.
• Dispense equal amounts of Base and Catalyst into the mixing tip.
• Mix thoroughly by extruding the material onto a mixing pad until a uniform color is obtained.
• Load the mixed light body material into the impression tray using a suitable syringe or dispenser.
• Apply the light body material around the prepared tooth or teeth, ensuring complete coverage and detail registration.
• Seat the tray over the dental arch and hold in place until set.

Final Steps:

• Once the impression is set, carefully remove it from the patient's mouth, ensuring minimal distortion.
• Rinse the impression with water to remove any debris.
• Inspect the impression for accuracy and detail reproduction.
• Pour gypsum material into the impression to create a working cast.
• Allow the gypsum to set according to manufacturer instructions.
• Trim and finish the working cast as needed for further dental procedures.

Storage and Handling:

• Store the components in a cool, dry place away from direct sunlight.
• Follow manufacturer guidelines for storage temperature and shelf life.
• Ensure proper closure of containers to prevent contamination.
• Dispose of unused materials according to local regulations.

• Exhibits pseudo-plastic properties for precision which is not found in alginates
• Superior tear strength than any other VPS material
• Better dimensional stability – multiple models can be poured up to two weeks
• Good hydrophilicity
• Compatible with gypsum products
• Superior wetting characteristics ensuring gypsum working cast is hard with smooth surface
• Can be subjected to cold sterilization without compromising the details and dimensional stability of the impression
• Better reproduction detail.
• Exhibits pseudo-plastic properties for precision which is not found in alginates
• Superior tear strength than any other VPS material
• Better dimensional stability – multiple models can be poured up to two weeks
• Good hydrophilicity
• Compatible with gypsum products
• Superior wetting characteristics ensuring gypsum working cast is hard with smooth surface
• Can be subjected to cold sterilization without compromising the details and dimensional stability of the impression
• Better reproduction detail.