Waldent FissureSeal Pit & Fissure Sealant LC

Composition

• Silanated Barium Glass Powder (Inorganic fillers)
• Urethane Dimethacrylate
• Triethylene Glycol Dimethacrylate
• Amorphous Fumed Silica
• Curing Agents, and Stabilizer.

Storage

• Store in a cool and dry place
• Store at room temperature of 5-30°C
• Do not freeze
• Store away from direct sunlight

• Use a non-fluoridated and oil-free prophylaxis paste to clean the occlusal surface of teeth with pit and fissure sites
• Remove minimal caries from pits and fissures using small round burs in a
  slow-speed handpiece, being careful not to extend beyond the affected area.
• Rinse thoroughly with water and isolate the tooth.
• Ensure the surface is dry by using clean, dry, oil-free air before etching
• Apply 37% phosphoric acid, like Waldent BestEtch, on the occlusal surface for 10-15 seconds, not exceeding 30 seconds.
• Thoroughly rinse with water
• Completely dry the tooth surface with oil-free air for 15 seconds.
• Place Waldent FissureSeal on the prepared tooth surface.
• Use the Waldent Eco Plus LED Light Curing Unit or any other LED curing light to cure the sealant for 20 seconds.
• Additional increments may be applied if necessary with continued isolation and dry operating site.

• Highly resistant to wear & tear.
• Fluoride release prevents decay and strengthens enamel.
• Easy-to-use syringe delivery system.
• Prevents food & microbes entrapment into pits & fissures.
• Forms a strong bond with enamel for long-lasting protection.
• Low shrinkage for a tight seal, optimal retention.
• Radiopaque for easy identification during check-ups.
• Highly resistant to wear & tear.
• Fluoride release prevents decay and strengthens enamel.
• Easy-to-use syringe delivery system.
• Prevents food & microbes entrapment into pits & fissures.
• Forms a strong bond with enamel for long-lasting protection.
• Low shrinkage for a tight seal, optimal retention.
• Radiopaque for easy identification during check-ups.