Voco Rebilda Dc - Set & Refills

A) Preparing the Tooth:

• Take appropriate measures to protect areas close to the pulp.
• Ensure that the tooth is properly prepared for core build-up or post luting, following standard dental procedures and techniques.

B) Bonding Material:

• Rebilda DC is used in the adhesive technique in combination with a light- or dual-curing adhesive that must be compatible with dual-curing composites.
• Consult the product's instructions for use to determine the correct preparation (etching technique) and procedure for bonding.

C1) Using Rebilda DC in the Cartridge:

• Insert the Rebilda DC cartridge into the VOCO dispenser (type 3) or any other extruder gun with a suitable piston.
• Remove the cap, and press out the material until an equal amount has been squeezed out of both outlets.
• Insert a mixing tip type 12 and lock it with a 90° turn clockwise. If needed, attach an additional intraoral tip type 3 onto the mixing tip.
• For root canal application, use a mixing tip type 19 with an integrated metal cannula. You can pre-bend the cannula by hand.
• Press the lever to extrude the material and mix it automatically in the correct ratio.

C2) Using Rebilda DC in the QuickMix Syringe:

• Remove the cap and press out the material from the QuickMix syringe until an equal amount comes out of both outlets.
• Place a mixing tip type 11, ensuring the notches on the syringe and the mixing tip line up exactly. Fix the mixing tip with a 90° turn clockwise.
• If necessary, add an application tip type 4 on top of the mixing tip. The material is mixed automatically in the correct ratio when dispensing and can be applied directly.

D) Application of the Core Build-Up Material:

• Place a matrix around the prepared tooth to contain the material.
• Apply Rebilda DC directly from the cartridge or QuickMix syringe to the prepared tooth.
• For light-curing, use transparent matrices for optimal results. Place the light-curing device's tip as close as possible to the surface of the core build-up and polymerize for 40 seconds using an LED/halogen lamp with a light output of at least 500 mW/cm². If the distance is more than 5 mm, the curing depth may be reduced.
• For larger core build-ups, apply in layers of 2 mm and cure each layer for 40 seconds.
• After light-curing, the material can be finished immediately.
• Without light-curing, the build-up can be finished 5 minutes after its application in the mouth.

• Light-curing for time-saving application
• Additional chemical curing for safe polymerisation
• Available in 10 g QuickMix syringes and 50 g cartridge
• In three shades: blue for easy identification of preparation margins, dentine for aesthetic reasons, white as an aesthetic contrast to dentine
• Low heat development even in bulk application
• Flowable – packing is obsolete
• Safe adhesion with system bond
• Optimised small mixing tips save material
• Easy access of posterior areas with intraoral tips
• Light-curing for time-saving application
• Additional chemical curing for safe polymerisation
• Available in 10 g QuickMix syringes and 50 g cartridge
• In three shades: blue for easy identification of preparation margins, dentine for aesthetic reasons, white as an aesthetic contrast to dentine
• Low heat development even in bulk application
• Flowable – packing is obsolete
• Safe adhesion with system bond
• Optimised small mixing tips save material
• Easy access of posterior areas with intraoral tips