Voco Profibase Maxillae 50 Pieces

• Product Type: Light-Curing Resin
• Processing Conditions: Suitable for Room and Daylight
• Post-Cure Flavor: Suitable for Room and Daylight
• Polymerization Time: 3 - 5 Minutes (Depending on Tray Thickness)
• Storage Conditions: 4°C to 23°C, Avoid Direct Sunlight
• Store at temperatures of: 4 °C to 23 °C. Avoid direct sunlight.

Preparation:

• Before starting, allow Voco Profibase Maxillae to reach room temperature.
• Ensure you have all necessary equipment, including a standard light unit (halogen or UVA light), plaster models, and any additional tools required for your specific application.

Fabrication of Individual Tray:

• Mark the margins for the individual tray on the plaster model. If needed, use a space maintainer. If not, insulate the plaster model.
• Remove the protective foil from a Profibase Maxillae plate.
• Carefully mold the plate onto the model, ensuring it covers the marked area.
• Cut the desired rim as marked.
• Shape a handle from the excess material if necessary.
• Polymerize Profibase on the model using a standard light unit. Depending on the thickness of the tray, polymerize the reverse side for 3 - 5 minutes. A longer polymerization time can enhance the material's physical properties, so adjust as needed.
• Once polymerized, the individual tray is immediately ready for use and can be worked upon without delay.

Fabrication of a Base Plate:

• Mark the margin of the planned prosthesis base on the plaster model.
• Block out any undercuts as usual.
• Thinly isolate the model with an alginate isolation.
• Carefully place a plate of Profibase Maxillae onto the model, ensuring it covers the marked area.
• Adjust the rims with a penknife or suitable tool.
• Polymerize the model with the base plate for 5 minutes in a standard halogen or UVA light unit. One single exposure is usually sufficient.

Supplementary Information:

• For finishing the rims and the ridge, hard metal burs are most suited. Create cross-shaped retentions on the ridge before applying wax. A thin layer of sticky wax can be applied for further customization.

Precautionary Measures:

• Profibase contains specific ingredients; do not use it if you or the patient has known hypersensitivities or allergies to any of these components.
• Ensure sufficient and complete polymerization, as a too short exposure time or low light intensity may lead to a loss of stability.

6. Storage:

• Store Voco Profibase Maxillae at temperatures between 4°C to 23°C. Avoid direct sunlight. Excess material can be used again if stored under light protection.

Expiry Date:

• Do not use the product after the specified expiry date.

• Gingiva shade
• Simple and time-saving shaping by hand
• Permanent stability and compressive strength
• Pleasant mint flavour
• Non-sticky consistency
• Light-cured with standard halogen light (e.g. Individo Light Box) or UVA lights