Composition : Dimethacrylate, 2-Hydroxyethyl Methacrylate, Camphorquinone, Dimethyl Amino Ethyl Methacrylate, Ethyl 4-dimethyl Amino Banzoate, Ethanol, Water, 10- BisGMA, Urethane Dimethacrylate, Triethylene Glycol Methacrylovloxydececyl Dihydrogen Phosphate, Butylated Hydroxy Toluene.
Techincal Data :
- Curing Time : 20-30 sec.
- Shear Bond Strength : 20-30 MPa
Chemistry : Ethanol-water based adhesive contain 10 MDP a functional monome
1.Direct Restorations :
SELF-ETCHING TECHNIQUE: Prepare cavity. Wash thoroughly with water spray. Use an absorbent pellet or high volume evacuation (HVE) for 1-2 seconds, to remove excess water (do not desiccate).
SELECTIVE ETCHING TECHNIQUE : Prepare cavity. Wash thoroughly with water spray. Etch enamel using an etchant for 15 seconds. Rinse thoroughly. Remove excess water by blotting the surface with an absorbent pellet or high volume evacuation (HVE) for 1-2 seconds, leaving the preparation visibly moist.
a. Dispense 1-2 drops of Renew MDP into a clean wel. Replace the cap onto the bottle promptly to avoid evaporation of solvent.
b. Apply two separate coats of Renew MDP, scrubbing the preparation with a microbrush for 10-15 seconds per coat. Do not light cure between coats.
c. Evaporate excess solvent by thoroughly air-drying with an air syringe for at least 10 seconds, there should be no visible movement of the adhesive. The surface should have a uniform glossy appearance; otherwise, apply an additional coat of Renew MDP and repeat Steps 2 and 3.
d. Light cure for 20 seconds.
e. Continue with placement of the restorative material according to the manufacturer's instructions.
2. Indirect Restorations :
SELF-ETCHING TECHNIQUE: Prepare cavity. Wash thoroughly with water spray. Use an absorbent pellet or high volume evacuation (HVE) for 1-2 seconds to remove excess water (do not desiccate).
SELECTIVE ETCHING TECHNIQUE: Prepare cavity. Wash thoroughly with water spray. Etch enamel using an etchant for 15 seconds. Rinse thoroughly. Remove excess water by blotting the surface with an absorbent pellet or high volume evacuation (HVE) for 1-2 seconds, leaving the preparation visibly moist.
a. Dispense 1-2 drops of Renew MDP into a clean well. Replace the cap onto the bottle promptly to avoid evaporation of solvent.
b. Apply two separate coats of Renew MDP, scrubbing the preparation with a microbrush for 10-15 seconds per coat. Do not light cure between coats.
c. Evaporate excess solvent by thoroughly air-drying with an air syringe for at least 10 seconds, there should be no visible movement of the adhesive. The surface should have a uniform glossy appearance; otherwise, apply an additional coat of Renew MDP and repeat Steps 2 and 3.
d. Light cure for 10 seconds.
e. Continue with cementation.
