Removal of Temporary Restoration and Cleaning:
- Remove temporary luting cement from the cavity.
- Clean the cavity with a polishing brush and an oil and fluoride-free cleaning paste.
- Rinse with water spray and dry with oil-free air. Avoid over-drying.
- Do not use alcohol for cleaning, as it may dehydrate dentin.
Try-in of the Restoration and Drying:
- Check the shade, fit, and occlusion of the restoration.
- Make necessary adjustments with fine diamonds if needed, using water for cooling.
- Use rubber dams or alternative isolation methods to prevent contamination.
- If contamination occurs, clean the dental hard tissue again.
Pre-treatment of the Restoration:
- Rinse the restoration and dry it with oil-free air.
- Coat the bonding surface with Ivoclean and allow it to react.
- Rinse the restoration and dry it with oil-free air.
- Apply Monobond N if necessary, following the specific guidelines for the restoration type.
Mixing of Multilink N Primer A and B:
- Mix Multilink N Primer A and B in a 1:1 ratio (within a 10-minute window).
Application of the mixed Multilink N Primer A/B:
- Apply the mixed primer onto the entire bonding surface.
- Start with the enamel surface and scrub it in.
- Disperse excess with blown air; no light-curing is necessary.
Application of Multilink N to the Restoration:
- Dispense Multilink N onto the restoration.
- Apply it directly to the inner surface of the restoration.
Placement of the Restoration and Removal of Excess Cement:
- Seat the restoration and secure it in place.
- Remove excess material immediately with suitable tools.
- Follow the specific technique instructions for self-curing, self-curing with additional light-curing, or other methods.
Finishing of the Restoration:
- Finish the cement joints if necessary.
- Polish restoration margins and cement joints with suitable polishers.
- Check occlusion and function and make adjustments as needed.
