SKU:
BARCODE:

Ivoclar Variolink N Lc

Rs. 3,700.00

Shipping calculated at checkout.

People are currently viewing this

In stock!

Selling quickly! people have this item in their carts

Type: N Lc -Clear

Description

Variolink N LC is an esthetic light-cure luting material especially suitable for adhesive cementation in the anterior region. Variolink N LC is recommended for very thin (<2mm) and highly translucent restorations. It is available in 3 versions. The different shades of Variolink N LC offer the option of a brightening effect. Due to the special amine-reduced formulation it supports shade stability and lowers the risk of discolouration caused by exposure to intensive daylight.

Indications:

Adhesive cementation of translucent all-ceramic restorations with a thickness of < 2.0mm (veneers, inlays, onlays)

Specifications

Care Instruction

Features

Shades:

Clear: Neutral effect (50% translucency)
+1: Little brightening (24% translucency)
+2: Brightening, whitening effect (12% translucency)

Clean the preparation with a polishing brush and a fluoride free cleaning paste
Rinse the preparation with water spray and dry it with water and oil-free air
For optimum esthetic results use variolink N try and paste to evaluate the shade of the restoration
Check the shade effect, accuracy of the fit and occlusion of the restoration
Thoroughly rinse off the trying paste with water spray after trying and dry the preparation with water and oil-free air
Etch the bonding surface of the restoration with 5% Hydrofluoric acid (ceramic etching gel) for 20 sec
Rinse off the etching gel and dry the restoration
Clean the bonding surface with ivoclean and leave it for 20 sec
Rinse off ivoclean and dry the restoration
Apply monobond n bonding agent to the pre-treated surface using a brush and allow it to react for 60 sec then disperse it with dry air
Isolate the operating field
Apply phosphoric acid etchnat to etch enamel for 15-30 seconds and dentin for 10-15 sec
Thouroughly rinse the gel with vigorous stream of water and air dry the preparation
Coat the entire bonding surface with bonding agent and scrub the adhesive in for 20 sec. Disperse the adhesive using air
Light cure bonding for 10 sec
Apply the desired amount of Variolink N LC directly from the syringe on to the restoration
Seat the restoration and retain it in place exerting uniform pressure
Remove gross excess material within the processing time especially in proximal and gingival area
Maintain the pressure and light cure the central area of the restoration for 3-4 seconds
Cover the restoration margins with glycerine gel to prevent oxygen inhibition
Light cure the restoration again for 10 seconds
Rinse off the glycerine gel
Finish the proximal sufaces with finishing and polishing strips. Polish the restoration margins with composite polishers